I’ve tested it at the Swedish network ”Kabelvisionen” with great results. It should also work at ”Telia” and ”Svenska Kabel TV”. It manages to decode all 28 channels ”Kabelvisionen” is offering including Filmnet 1 & 2, TV1000, TV1000 Cinema and Hallmark.
Please send any coment or if you’ve tested it on another system and
it works to:
nicron@bigfoot.ocm
Another way to code a TV signal is to manipulate with the signal's syncronisation and polarity. The coded picture may roll and you can’t see a thing. You can’t hear anything eigther. When the picture ain’t syncronised, the TV won't know where the picture starts or ends. Maxidecoder v1.0 is made for this.
Make sure that you connect the koax and the scart connector to the same device. It wont work unless. Connect the antenna to the decoder.
1. Power on the decoder. Switch to a UNCODED channel. Adjust the TV to normal brigthness. Make the following adjustments: p1 fully to the right, p2 centerd, p3 centerd, p4 fully to the right, p5 fully to th left, p5 fully to the right and c1 centerd.
2. When you are finnished with this step, you’ll have a brigth wide line over the screen. Turn p2 until you have a stable picture. If you can’t get it stable, try adjusting p3 a bit and then p2 again.
3. When you are finnished with this step, the wide line will be gone but the picture is brigther than before. Turn p4 until the wide line just dissapear to the left. If you can’t see the left edge, turn p4 fully left and then turn it back until it dissapers. Turn p1 until the rigth edge dissapears to the right.
4. Adjust p5 until the distortions in the top of the sceen just dissapears.
5. Switch to an CODED channel. Turn p6 fully left. Adjust c1 until the coded channel appears. Note that the picture may dissapear when you touch c1 with a iron screwdriver. Turn to another coded channel and adjust c1 until it appears. Now you have to get true all coded channels and find the right setting for c1. When this is done, you can adjust the coded channels brigthness with p6. Here you will have to compromise besauce you can’t get the same brightness at all channels, the decoder ain’t that good yet.
If you heaven’t got any picture at any coded channel it’s probably p2 that needs an adjustment. If this ain’t working, try increase the brigthness with p6 and if this ain’t working try c1.
· The picture is unstable at the top.
Try p2 and if that ain’t working at all try p5. If nothing of this works, try turn p3 a little bit more to the right.
· The picture is unstable in the sides.
Turn up p6. if this doesn’t work, try p4 or p3.
· Prolems when connecting it to another TV or Video.
Adjust p3 for the incoming signal level, and p6 / c1 for the brightness.
· The picture is to bright.
Is it an uncoded cannel ? If it is, switch off the decoder and if not, adjust p6 / c1.
· I can’t get the autosearch to stop at a coded channel.
Try adjust p6 / c1 for maximum brightness. It will find the cannels easier then.
